Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 472

JUNOSe 11.0.x Broadband Access Configuration Guide
If a nondefault L2TP RWS is configured for a particular host profile, to display the
RWS setting as an attribute of that host profile:
host1#show l2tp destination profile westford
L2TP destination profile westford
Configuration
Statistics
Host profile attributes
5 L2TP host profiles found
Table 86 on page 433 lists the show l2tp destination profile command output fields.
Meaning
432
Monitoring Configured Destination Profiles or Host Profiles
Destination address
Transport ipUdp
Virtual router lns
Peer address 192.168.1.99
Destination profile maximum sessions is 5000
Destination profile current session count is 2
Remote host is remhost22.xyz.com
Configuration
Tunnel password is 23erf5
Interface profile is ebcints
Bundled group id is 1
Bundled group id override is enabled
Maximum sessions is 400
Failover resync is failover-protocol
Statistics
Current session count is 14
Remote host is asciitext
Configuration
Bundled group id is 0
Tunnel password is 222
Interface profile is ascints
Default upper binding type mlppp
Maximum sessions is 250
Failover resync is failover-protocol
Statistics
Current session count is 2
Remote host is mexico
Configuration
Local ip address is 10.10.2.2
Proxy lcp is disabled
Proxy authenticate is enabled
mlppp upper binding type
Disconnect-cause avp is enabled
Receive window size is 4
Maximum sessions is 500
Failover resync is failover-protocol
Statistics
Current session count is 14
Remote host is LAC
Configuration
Tunnel password is TunnelPass
Local host name is LNS
Local ip address is 46.1.1.2
Disconnect-cause avp is enabled
Tunnels are single-shot
Override out-of-resource-result-code is enabled
Statistics
Current session count is 0