Framed-Ipv6-Pool; Delegated-Ipv6-Prefix - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide

[100] Framed-Ipv6-Pool

Use the following command to manage the Framed-Ipv6-Pool RADIUS attribute.
radius include framed-ipv6-pool

[123] Delegated-Ipv6-Prefix

Use the following command to manage the Delegated-Ipv6-Prefix RADIUS attribute.
radius include delegated-ipv6-prefix
212
CLI Commands Used to Modify RADIUS Attributes
When the Framed-Ipv6-Route attribute is not returned from the RADIUS server
in the Access-Accept message, the immediate accounting, Acct-Stop, or
Interim-Acct messages do not report this attribute.
See radius include
Example
host1(config)#radius include framed- ipv6-route acct-start enable
Use the no version to restore the default, disable.
radius include framed-ipv6-pool
Use to include the Framed-Ipv6-Pool attribute in Acct-Start or Acct-Stop messages.
You can control inclusion of the Framed-Ipv6-Pool attribute by enabling or
disabling this command.
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.
If the IPv6 pool name is configured in the AAA domain map using the CLI and
is not returned from RADIUS server, the Acct-Start, Acct-Stop, or Interim-Acct
messages report the value configured in the domain map.
See radius include
Example
host1(config)#radius include framed- ipv6-pool acct-start enable
Use the no version to restore the default, disable.
radius include delegated-ipv6-prefix
Use to include the Delegated-Ipv6-Prefix attribute in Acct-Start or Acct-Stop
messages.
You can control inclusion of the Delegated-Ipv6-Prefix attribute by enabling or
disabling this command.
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.