Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 78

JUNOSe 11.0.x Broadband Access Configuration Guide
2.
3.
4.
5.
NOTE: For more information about these SNMP commands, see JUNOSe System
Basics Configuration Guide.
radius trap acct-server-not-responding
radius trap acct-server-responding
radius trap auth-server-not-responding
38
Configuring RADIUS Authentication and Accounting Servers
host1(config)#snmp-server community admin view everything rw
host1(config)#snmp-server community private view user rw
host1(config)#snmp-server community public view everything ro
Specify the interface whose IP address is the source address for SNMP traps.
host1(config)#snmp-server trap-source fastEthernet 0/0
Configure the host that should receive the SNMP traps.
host1(config)#snmp-server host 10.10.132.93 version 2c 3 udp-port 162 radius
Enable the SNMP router agent to receive and forward RADIUS traps.
host1(config)#snmp-server enable traps radius
Enable the SNMP on the router.
host1(config)#snmp-server
Use to enable or disable SNMP traps when a particular RADIUS accounting server
fails to respond to a RADIUS accounting request.
The associated SNMP object is rsRadiusClientTrapOnAcctServerUnavailable.
Example
host1(config)#radius trap acct-server-not-responding enable
Use the no version to return to the default setting, disable.
See radius trap acct-server-not-responding
Use to enable or disable SNMP traps when a RADIUS accounting server returns
to service after being marked as unavailable.
The associated SNMP object is rsRadiusClientTrapOnAcctServerAvailable.
This command affects only the current VR context.
Example
host1(config)#radius trap acct-server-responding enable
Use the no version to restore the default, disable.
See radius trap acct-server-responding