Acct-Delay-Time - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide
radius remote-circuit-id-delimiter
Related Topics

[41] Acct-Delay-Time

Use the following commands to manage and display information for the
Acct-Delay-Timer RADIUS attribute.
198
CLI Commands Used to Modify RADIUS Attributes
You can use this command to configure the following nondefault formats for the
PPPoE remote circuit ID value:
Include either or both of the agent-circuit-id and agent-remote-id suboptions,
with or without the NAS-Identifier [32] RADIUS attribute
Append the agent-circuit-id suboption value to an interface specifier that is
consistent with the recommended format in the DSL Forum Technical Report
(TR)-101 Migration to Ethernet-Based DSL Aggregation (April 2006).
For more information about how to use this command, see the Using the PPPoE
Remote Circuit ID to Identify Subscribers and Configuring PPPoE Remote Circuit
ID Capture sections in JUNOSe Link Layer Configuration Guide.
See radius remote-circuit-id-format
Examples
host1(config)#radius remote-circuit-id-format nas-identifier agent-circuit-id
agent-remote-id
host1(config)#radius remote-circuit-id-format dsl-forum-1
Use the no version to restore the default format, agent-circuit-id.
Use to configure the delimiter character that the router uses to set off multiple
components in the format of the PPPoE remote circuit ID value captured from
a DSLAM.
For information about how to use this command, see the Configuring PPPoE
Remote Circuit ID Capture section in JUNOSe Link Layer Configuration Guide.
See radius remote-circuit-id-delimiter
Example
host1(config)#radius remote-circuit-id-delimiter !
Use the no version to restore the default delimiter character, #.
Monitoring Override Settings of RADIUS IETF Attributes on page 297
Monitoring the NAS-Identifier RADIUS Attribute on page 299
Monitoring the Format of the Remote-Circuit-ID for RADIUS on page 300
Monitoring the Delimiter Character in the Remote-Circuit-ID for RADIUS on
page 300