Table 49: Radius Ietf Attributes Supported By Junose Software; Chapter 6 Radius Attribute Descriptions - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Chapter 6
RADIUS Attribute Descriptions
RADIUS IETF Attributes

Table 49: RADIUS IETF Attributes Supported by JUNOSe Software

Attribute
Number Attribute Name
[1] User-Name
[2] User-Password
[3] CHAP-Password
[4] NAS-IP-Address
This chapter lists the RADIUS attributes that are supported by JUNOSe software.
Table 49 on page 253 describes the supported RADIUS IETF attributes. Table 50 on
page 259 describes the supported Juniper Networks vendor-specific attributes (VSAs).
Table 51 on page 270 describes the DSL Forum VSA formats supported by JUNOSe
software. Table 52 on page 272 describes RADIUS attributes that are simply passed
to their destination by the router.
RADIUS attributes are discussed in the following sections:
RADIUS IETF Attributes on page 253
Juniper Networks VSAs on page 259
DSL Forum VSAs on page 270
Pass Through RADIUS Attributes on page 271
RADIUS Attributes References on page 272
Table 49 on page 253 describes the RADIUS IETF attributes supported by JUNOSe
software. The attributes are sorted by standard number.
Description
Name of user to be authenticated
Configurable username override
Password of user to be authenticated
Configurable password override
Password Authentication Protocol (PAP)
Response value provided by a Point-to-Point Protocol (PPP) Challenge Handshake
Authorization Protocol (CHAP) user in the response to an access challenge
IP address of the network access server (NAS) that is requesting authentication
of the user
You can use the radius update-source-addr command to override this
behavior; see "Configuring Remote Access" on page 3.
RADIUS IETF Attributes
253