Tunnel-Type - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide
radius ethernet-port-type
radius include nas-port-type
Related Topics

[64] Tunnel-Type

Use the following command to manage the Tunnel-Type RADIUS attribute.
radius include tunnel-type
204
CLI Commands Used to Modify RADIUS Attributes
Use the no version to restore the default, xdsl.
See radius dsl-port-type
Use to set the NAS-Port-Type attribute for Ethernet interfaces to ethernet or
virtual.
See radius ethernet-port-type
Example
host1(config)#radius ethernet-port-type virtual
Use the no version to restore the default, ethernet.
Use to include the NAS-Port-Type attribute in Access-Request, Acct-Start, and
Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include nas-port-type acct-start enable
Use the no version to restore the default, enable.
Monitoring the DSL-Port-Type RADIUS Attribute on page 301
radius include tunnel-type
Use to include the Tunnel-Type attribute in Access-Request, Acct-Start, and
Acct-Stop messages.
You can control inclusion of the Tunnel-Type attribute by enabling or disabling
this command.
See radius include
Example
host1(config)#radius include tunnel-type access-request enable