Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 69

aaa user accounting interval
aaa virtual-router
host1(config)#aaa duplicate-address-check enable
There is no no version.
See aaa duplicate-address-check
Use to specify the default interval between user accounting updates. The router
uses the default interval when no value is specified in the RADIUS
Acct-Interim-Interval attribute (RADIUS attribute 85).
This command and the aaa service accounting interval command replace the
aaa accounting interval command, which is deprecated and might be removed
in a future release. For information about setting the default interim accounting
interval for services, see "Configuring Service Manager" on page 635.
The default interval is applied on a virtual router basis this setting is used for
all users who attach to the corresponding virtual router.
Specify the user accounting interval in the range 10–1440 minutes. The default
setting is 0, which disables the feature.
Example
host1(config)#aaa user accounting interval 20
Use the no version to reset the accounting interval to 0, which turns off interim
user accounting when no value is specified in the RADIUS Acct-Interim-Interval
attribute.
See aaa user accounting interval
Use to add virtual routers to a virtual router group. During AAA broadcast
accounting, accounting records are sent to the accounting servers on the virtual
routers in the named virtual router group.
You can add up to four virtual routers to a virtual router group. Use the
indexInteger parameter to specify the order (1–4) in which the virtual routers
receive the accounting information. The indexInteger is used with the no version
to delete a specific virtual router from a group (see Example 2).
A virtual router name consists of 1–32 alphanumeric characters.
The virtual router names in the group must be unique. An error message appears
if you enter a duplicate name.
Example 1
host1(config)#aaa accounting vr-group westVrGroup38
host1(config-vr-group)#aaa virtual-router 1 vrWestA
host1(config-vr-group)#aaa virtual-router 2 vrWestB
host1(config-vr-group)#aaa virtual-router 4 vrSouth1
Example 2
host1(config-vr-group)#no aaa virtual-router 2
Configuring RADIUS Authentication and Accounting Servers
Chapter 1: Configuring Remote Access
29