Using Aaa Tunnel Groups To Configure The Transmit Connect Speed Calculation Method - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

2.
3.

Using AAA Tunnel Groups to Configure the Transmit Connect Speed Calculation Method

To configure the transmit connect speed calculation method for a tunneled L2TP
session associated with an AAA tunnel group:
1.
2.
3.
For more information about how to map a domain to an L2TP tunnel from
Domain Map Tunnel Configuration mode, see "Mapping a User Domain Name
to an L2TP Tunnel Overview" on page 352 .
From Domain Map Tunnel Configuration mode, configure the calculation method
for the transmit connect speed of the subscriber's access interface.
host1(config-domain-map-tunnel)#tx-connect-speed-method dynamic-layer2
(Optional) Use the show aaa domain-map command to verify configuration of
the transmit connect speed calculation method.
host1(config-domain-map-tunnel)#run show aaa domain-map
Domain: sunnyvale.com; router-name: lac; ipv6-router-name: default
Tunnel Tunnel Tunnel
Tag Peer Source
------ ------ ------
5 <null> <null>
Tunnel
Tunnel Server Tunnel
Tag Name Preference
------ ------ ----------
5 <null> 2000
Tunnel Tunnel
Tunnel Failover Switch
Tag Resync Profile
------ -------- -------
5 <null> <null>
Access Tunnel Group Tunnel Configuration mode.
host1(config)#aaa tunnel-group boston
host1(config-tunnel-group)#tunnel 3
host1(config-tunnel-group-tunnel)#
For more information about how to map a domain to an L2TP tunnel from Tunnel
Group Tunnel Configuration mode, see "Mapping a User Domain Name to an
L2TP Tunnel Overview" on page 352.
From Tunnel Group Tunnel Configuration mode, configure the calculation method
for the transmit connect speed of the subscriber's access interface.
host1(config-tunnel-group-tunnel)#tx-connect-speed-method qos
(Optional) Use the show aaa tunnel-group command to verify configuration of
the transmit connect speed calculation method.
Configuring the Transmit Connect Speed Calculation Method
Chapter 13: Configuring an L2TP LNS
Tunnel Tunnel Tunnel
Type Medium Password
------ ------ --------
l2tp ipv4 <null>
Tunnel
Max
Sessions Tunnel RWS
-------- --------------
0 system chooses
Tunnel
Tx
Speed Method
--------------
dynamic layer2
Tunnel
Tunnel Client
Id Name
------ ------
<null> <null>
Tunnel
Virtual
Router
-------
<null>
399