Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 97

NOTE: If a pool or range is deleted and addresses are outstanding, the AAA server
logs out the clients using the addresses.
address-pool-name
backup-address-pool-name
host1(config-domain-map)#backup-address-pool-name backup_poolB
(Optional) Map the domain name to the IPv6 local address pool, which is used
for prefix delegation. If the authentication server returns the prefix pool name
in the Framed-Ipv6-Pool attribute of the RADIUS-Accept-Request message, this
value overrides the IPv6 local pool configured using the ipv6-prefix-pool-name
command.
host1(config)#aaa domain-map westford.com
host1(config-domain-map)#ipv6-prefix-pool-name local_addr_pool
Delete an address pool.
host1(config)#no ip local pool addrpool_10
Create a shared local address pool.
host1(config)#ip local shared-pool Shared_LAS_Pool_A DHCP_Pool_1
Delete a shared local address pool.
host1(config)#no ip local shared-pool Shared_LAS_Pool_C
Set SNMP variables by specifying an existing pool name and values.
host1(config)#ip local pool addrpool_10 warning 90 80
Use to specify the name of the primary local address pool from which the router
allocates addresses for the domain that you are configuring.
If the authentication server does not return an address, the router allocates an
address from this pool. The authentication server may override this pool name
using RADIUS attributes such as Framed-Pool.
The primary pool name is a character string up to 16 characters long.
Example
host1(config)#aaa domain-map westford.com
host1(config-domain-map)#address-pool-name poolA
Use the no version to remove the primary local address pool name.
See address-pool-name
Chapter 1: Configuring Remote Access
Configuring Local Address Servers
57