Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 716

JUNOSe 11.0.x Broadband Access Configuration Guide
statistics
NOTE: Service Manager statistics collection is a three-part procedure. You must
configure statistics information in the service definition macro file, enable statistics
collection by either RADIUS or the CLI, and also enable statistics collection for the
policy referenced in the service macro using the statistics enabled keyword in the
command used for policy attachment in the profile. See "Configuring Service Manager
Statistics" on page 680.
time
676
Using the CLI to Manage Subscriber Service Sessions
Use to create a new service session profile or to specify the name of an existing
profile you want to modify, and to enter Service Session Profile Configuration
mode.
In Service Session Profile Configuration mode, you specify the attributes used
in the service session profile, such as the maximum volume limit for the session
and the maximum time the session can be used. You can also specify that Service
Manager collect statistics for time, or volume, or both.
Example
host1(config)#service-management service-session-profile vodISP1
host1(config-service-session-profile)#
Use the no version to delete the service session profile.
See service-management service-session-profile
Use to enable statistics collection and to specify the type of statistics to collect.
Use the time keyword to collect statistics about the duration of the service
session.
Use the volume-time keyword to collect statistics about both the volume of
traffic and the duration of the service session.
Example
host1(config)#service-management service-session-profile vodISP1
host1(config-service-session-profile)#statistics volume-time
Use the no version to disable statistics collection.
See statistics
Use to specify the maximum amount of time that the service session can be
active for the subscriber.
The router immediately terminates the subscriber's service session when the
specified time is exceeded.
The range is 0–16777251 seconds.
Example