Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 301

Table 50: Juniper Networks (Vendor ID 4874) VSA Formats (continued)
Attribute
Number Attribute Name
[26-14] Service-Category
[26-15] PCR
[26-16] SCR
[26-17] Mbs
[26-18] Init-CLI-Access-Level
[26-19] Allow-All-VR-Access
[26-20] Alt-CLI-Access-Level
[26-21] Alt-CLI-Vrouter-Name
[26-22] Sa-Validate
[26-23] Igmp-Enable
Description
ATM service category to apply to B-RAS
user's interface
Peak cell rate
4-octet integer
Sustained cell rate
4-octet integer
Maximum burst rate
4-octet integer
Specifies the initial level of access to
CLI commands
See the enable command in the
Passwords and Security chapter in
JUNOSe System Basics Configuration
Guide.
Specifies user access to all virtual
routers
See the enable command in the
Passwords and Security chapter in
JUNOSe System Basics Configuration
Guide.
Specifies other levels of access to CLI
commands
See the enable command in chapter
Passwords and Security in JUNOSe
System Basics Configuration Guide.
For restricted users, specifies other
VRs that the user may access.
See the enable command in chapter
Passwords and Security in JUNOSe
System Basics Configuration Guide.
Enable or disable source address
validation on a user's interface
4-octet integer
Enable or disable IGMP on a user's
interface
Allows the end user to register for the
reception of multicast services
4-octet integer
Chapter 6: RADIUS Attribute Descriptions
Subtype
Length Length Value
12 6 integer: 1= UBR,
2 = UBR PCR,
3 = NRT VBR,
4 = CBR
5 = RT VBR,
12 6 integer: 4-octet
12 6 integer: 4-octet
12 6 integer: 4-octet
len sublen single attribute: enter
0, 1, 5, 10, or 15
len sublen integer: 0 = disable,
1 = enable
len sublen single attribute; enter
0, 1, 5, 10, or 15
len sublen string:
virtual-router-name
len sublen integer: 0 = disable,
1 = enable
len sublen integer: 0 = disable,
1 = enable
Juniper Networks VSAs
261