Acct-Multi-Session-Id; Acct-Link-Count - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual
For e series broadband services routers - broadband access configuration
Hide thumbs
Also See for JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010:
- Configuration manual (712 pages)
Table of Contents
Advertisement
[50] Acct-Multi-Session-Id
Use the following command to manage the Acct-Multi-Session-Id RADIUS attribute.
radius include acct-multi-session-id
[51] Acct-Link-Count
Use the following command to manage the Acct-Link-Count RADIUS attribute.
radius include acct-link-count
You can control inclusion of the attribute by enabling or disabling this command.
See radius include.
Example
host1(config)#radius include acct-terminate-cause acct-off disable
Use the no version to restore the default, enable.
radius include acct-multi-session-id
Use to include the Acct-Multi-Session-Id attribute in Access-Request, Acct-Start,
or Acct-Stop messages.
You can control inclusion of the Acct-Multi-Session-Id attribute by enabling or
disabling this command.
See radius include
Example
host1(config)#radius include acct-multi-session-id acct-stop disable
Use the no version to restore the default, enable for accounting messages and
disable for access requests.
radius include acct-link-count
Use to include the Acct-Link-Count attribute in Acct-Start and Acct-Stop messages.
You can control inclusion of the Acct-Input-Gigawords attribute by enabling or
disabling this command.
See radius include
Example
host1(config)#radius include acct-link-count acct-stop disable
Use the no version to restore the default, enable.
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
201
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 and is the answer not in the manual?