Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 228

JUNOSe 11.0.x Broadband Access Configuration Guide
radius pppoe nas-port-format unique
radius vlan nas-port-format stacked
188
CLI Commands Used to Modify RADIUS Attributes
Port 3 bits
VLAN 12 bits
S-VLAN 12 bits
To set valid S-VLAN widths on Gigabit Ethernet and 10-Gigabit Ethernet interfaces,
you must include S-VLAN IDs in the NAS-Port attribute by issuing the
radius vlan nas-port-format stacked command.
The total number of bits for all fields cannot exceed 32. When the total number
of bits is less than 32, the NAS-Port attribute is right-justified and the extra bits
are set to 0. If you do not specify a value for a field, the number of bits is set
to 0.
See radius nas-port-format extended
Example 1 Sets the field widths for ATM interfaces
host1(config)#radius nas-port-format extended atm field-widths slot 4
adapter 1 vpi 7 vpi 17
Example 2 Sets the field widths for Gigabit Ethernet and 10-Gigabit Ethernet
interfaces
host1(config)#radius nas-port-format extended ethernet field-widths slot 4
adapter 1 port 3 vlan 12
Use the no version to restore the default behavior of the radius nas-port-format
command.
Use to set the NAS-Port attribute to a unique value for subscribers on PPPoE
interface. This unique value is derived from the subscriber's profileHandle.
See radius pppoe nas-port-format unique
Example
host1(config)#radius pppoe nas-port-format unique
Use the no version to return to the default, in which the value is determined by
the interface.
Use to include the S-VLAN ID, in addition to the VLAN ID, in the NAS-Port attribute
for subscribers on Ethernet interfaces.
The VLAN ID is always included whether the S-VLAN ID inclusion feature is
enabled or disabled.
The radius pppoe nas-port-format unique command overrides this command.
See radius vlan nas-port-format stacked