JUNOSe 11.0.x Broadband Access Configuration Guide
The Agent Remote ID suboption contains a value only when (1) the interface is a
dynamic ATM interface and (2) the subscriber command is used to configure a
username and domain name for the interface. If both conditions are met, the
506
Configuring DHCP Relay and BOOTP Relay
[<hostname>|<vrname>:]<interface type> <slot>/<port>[.<sub-if>]:<vlan id>
Examples:
fastEthernet 1/2.3:4
relayVr:fastEthernet 1/2:4
bostonHost:fastEthernet 1/2.3:4
Ethernet interface with Stacked VLAN
[<hostname>|<vrname>:]<interface type> <slot>/<port>[.<sub-if>]:
<svlan id>-<vlan id>
Examples:
fastEthernet 1/2.3:4-5
relayVr:fastEthernet 1/2:4-5
bostonHost:fastEthernet 1/2.3:4-5
LAG interface
[<hostname>|<vrname>:]<interface type> <bundle name>
Examples:
lag bundleA
relayVr:lag bundleA
bostonHost:lag bundleA
LAG interface with VLAN
[<hostname>|<vrname>:]<interface type> <bundle name>[.<sub-if>]:<vlan id>
Examples:
lag bundleA.1:2
relayVr:lag bundleA:2
bostonHost:lag bundleA.1:2
LAG interface with Stacked VLAN
[<hostname>|<vrname>:]<interface type> <bundle name>[.<sub-if>]:
<svlan id>-<vlan id>
Examples:
lag bundleA.1:2-3
relayVr:lag bundleA:2-3
bostonHost:lag bundleA.1:2-3