Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 627

ip use-framed-routes ip-subscriber
password
set ip interface-profile
set ip service-profile
Example
host1(config-if)#ip source-prefix 10.0.0.0 255.0.0.0
Use the no version to remove the association between the interface and the
specified IP source address and mask.
See ip source-prefix
Use to configure a static primary IP interface to use framed routes as source IP
addresses when creating dynamic subscriber interfaces. The router uses the
Framed-Route RADIUS attribute [22] sent in Access-Accept messages to apply
framed routes to subscriber interfaces associated with the primary interface.
Example
host1(config-if)#ip use-framed-routes ip-subscriber
Use the no version to disable the use of framed routes when creating dynamic
subscriber interfaces associated with this primary IP interface.
See ip use-framed-routes ip-subscriber
Use to specify the password for an IP service profile. The password is used as
the dynamically created password by JUNOSe subscriber management.
You can specify a password with up to 32 ASCII characters.
Example
host1(config-service-profile)#password mypassword
Use the no version to remove the password from the IP service profile.
See password
Use to specify a dynamic subscriber interface profile that is used in the route
map.
Example
host1(config)#route-map mapForEPort
host1(config-route-map)#set ip interface-profile disableUser
Use the no version to delete the interface profile from the route map.
See set ip interface-profile
Chapter 23: Configuring Subscriber Management
Subscriber Management Commands
587