Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 232

JUNOSe 11.0.x Broadband Access Configuration Guide
radius calling-station-format
192
CLI Commands Used to Modify RADIUS Attributes
Use to specify the format of the Calling-Station-Id [31] attribute on a virtual
router.
For each field in angle brackets (<>) in the Calling-Station-Id formats, the virtual
router supplies the actual value for your configuration, unless otherwise specified.
To specify that the RADIUS client use the delimited format when the PPP user
is terminated at the non-LNS E Series router, use the delimited keyword.
Format for ATM interfaces:
<delimiter> <system name> <delimiter> <interface> <delimiter>
<VPI> <delimiter> <VCI><delimiter>
Format for Ethernet interfaces:
<delimiter> <system name> <delimiter> <interface> <delimiter>
<VLAN>
Where <interface> is one of the following items:
<port name> The default setting
<VP description> Appears if you use the atm vp-description command
to assign a text description to an individual VP on an ATM interface
<VC description> Appears if you use the atm atm1483 description
command to assign a text description to VCs on an ATM 1483 subinterface
and you use the atm1483 export-subinterface-description command to
enable sending of VC interface descriptors to AAA
To specify that the RADIUS client use a fixed format of up to 15 characters
consisting of all ASCII fields, use the fixed-format keyword. The maximum
number of characters for each field is shown in square brackets ([ ]).
Format for ATM interfaces:
<system name [4]> <slot [2]> <port [1]> <VPI [3]> <VCI [5]>
Format for Ethernet interfaces:
<system name [4]> <slot [2]> <port [1]> <VLAN [8]>
Format for serial interfaces:
<system name [4]> <slot [2]> <port [1]> <0 [8]>
Where the final 8-byte field is always 0 (zero).
In the case of PPP terminated at the LNS, the Calling-Station-Id attribute is
based on the received L2TP calling number AVP.
To specify that the RADIUS client use a fixed format of up to 15 characters
consisting of all ASCII fields with a 1-byte slot field, 1-byte adapter field, and
1-byte port field, use the fixed-format-adapter-embedded keyword. The
maximum number of characters for each field is shown in square brackets ([ ]).
Format for ATM interfaces:
<system name [4]> <slot [1]> <adapter [1]> <port [1]>
<VPI [3]> <VCI [5]>
Format for Ethernet interfaces:
<system name [4]> <slot [1]> <adapter [1]> <port [1]>