Acct-Tunnel-Connection; Connect-Info - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide

[68] Acct-Tunnel-Connection

Use the following command to manage the Acct-Tunnel-Connection RADIUS attribute.
radius include acct-tunnel-connection

[77] Connect-Info

Use the following commands to manage and display information for the Connect-Info
RADIUS attribute.
radius connect-info-format
206
CLI Commands Used to Modify RADIUS Attributes
Use to include the Tunnel-Server-Endpoint attribute in Access-Request, Acct-Start,
and Acct-Stop messages.
You can control inclusion of the Tunnel-Server-Endpoint attribute by enabling
or disabling this command.
See radius include
Example
host1(config)#radius include tunnel-server-endpoint acct-stop disable
Use the no version to restore the default, enable.
radius include acct-tunnel-connection
Use to include the Acct-Tunnel-Connection attribute in Access-Request, Acct-Start,
or Acct-Stop messages.
You can control inclusion of the Acct-Tunnel-Connection attribute by enabling
or disabling this command.
See radius include
Example
host1(config)#radius include acct-tunnel-connection acct-stop enable
Use the no version to restore the default, enable.
radius connect-info-format l2tp-connect-speed
radius include connect-info
Use on the LNS to enable the generation of the RADIUS Connect-Info attribute
and to specify the attribute's format. The attribute is based on the L2TP
connect-speed AVPs for received (RX) speed (AVP 38) and transmit (TX) speed
(AVP 24). See "Configuring the RX Speed on the LAC" on page 359 for information
about generating the RX and TX speed AVPs.
The Connect-Info attribute is a string in the following format; the attribute is
generated whenever the TX speed is not zero.