Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 333

Table 55: Default PPP Mappings (continued)
PPP Terminate Reason
lcp no peer magicnumber
lcp no peer mrru
lcp no peer mru
lcp no peer pfc
lcp peer terminate code rej
lcp peer terminate term ack
lcp peer terminate term req
lcp peer terminate protocol reject
lcp peer renegotiate rx conf ack
lcp peer renegotiate rx conf nak
lcp peer renegotiate rx conf rej
lcp peer renegotiate rx conf req
lcp tunnel disconnected
lcp tunnel failed
link interface no hardware
lower interface attach failed
lower interface teardown
mpls admin disable
mpls link down
mpls max configure exceeded
mpls no service
mpls peer renegotiate rx conf ack
mpls peer renegotiate rx conf nak
mpls peer renegotiate rx conf rej
mpls peer renegotiate rx conf req
mpls peer terminate code rej
Chapter 7: Application Terminate Reasons
RADIUS Acct-Terminate-Cause
Code Description
10 nas request
10 nas request
10 nas request
10 nas request
1 user request
1 user request
1 user request
1 user request
1 user request
1 user request
1 user request
1 user request
10 nas request
10 nas request
8 port error
2 lost carrier
2 lost carrier
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
PPP Terminate Reasons
293