Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 125

Table 8: Supported RADIUS Acct-Terminate-Cause Codes (continued)
Code Name
2 Lost Carrier
3 Lost Service
4 Idle Timeout
5 Session Timeout
6 Admin Reset
7 Admin Reboot
8 Port Error
9 NAS Error
10 NAS Request
11 NAS Reboot
12 Port Unneeded
13 Port Preempted
14 Port Suspended
15 Service Unavailable
16 Callback
17 User Error
18 Host Request
19 Supplicant Restart
20 Reauthentication
Failure
21 Port Reinitialized
22 Port Administratively
Disabled
Mapping Application Terminate Reasons to RADIUS Terminate Codes
Chapter 1: Configuring Remote Access
Description
DCD was dropped on the port
Service can no longer be provided; for example, the user's
connection to a host was interrupted
Idle timer expired
Subscriber reached the maximum continuous time allowed for
the service or session
System administrator reset the port or session
System administrator terminated the session on the NAS; for
example, prior to rebooting the NAS
NAS detected an error on the port that required ending the
session
NAS detected an error (other than on the port) that required
ending the session
NAS ended the session for a non-error reason
NAS ended the session due to a non-administrative reboot
NAS ended the session because the resource usage fell below
the low threshold; for example, the bandwidth-on-demand
algorithm determined that the port was no longer needed
NAS ended the session to allocate the port to a higher-priority
use
NAS ended the session to suspend a virtual session
NAS was unable to provide the requested service
NAS is terminating the current session in order to perform
callback for a new session
An error in the user input caused the session to be terminated
The login host terminated the session normally
Supplicant state machine was reinitialized
A previously authenticated supplicant failed to reauthenticate
successfully following expiration of the reauthentication timer
or explicit reauthentication request by management action
The port's MAC has been reinitialized
The port has been administratively disabled
85