Service-Category; Pcr - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide

[26-14] Service-Category

Use the following command to manage the Service-Category RADIUS attribute.
radius ignore atm-service-category

[26-15] PCR

Use the following command to manage the PCR RADIUS attribute.
radius ignore atm-pcr
216
CLI Commands Used to Modify RADIUS Attributes
Use to cause the Egress-Policy-Name attribute to be ignored in Access-Accept
messages.
You can control this behavior by enabling or disabling this command.
See radius ignore
Example
host1(config)#radius ignore egress-policy-name enable
Use the no version to restore the default, disable.
radius ignore atm-service-category
Use to cause the Service-Category attribute to be ignored in Access-Accept
messages.
You can control this behavior by enabling or disabling this command.
See radius ignore
Example
host1(config)#radius ignore atm-service-category enable
Use the no version to restore the default, disable.
radius ignore atm-pcr
Use to cause the PCR attribute to be ignored in Access-Accept messages.
You can control this behavior by enabling or disabling this command.
See radius ignore
Example
host1(config)#radius ignore atm-pcr enable
Use the no version to restore the default, disable.