Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 270

JUNOSe 11.0.x Broadband Access Configuration Guide
Table 44: ANCP (L2C)-Related Keywords for radius include Command (continued)
NOTE: JUNOSe software continues to support DSL Forum VSAs (vendor ID 3561)
that you can use to include DSL-related information in RADIUS messages. See "DSL
Forum VSAs" on page 270.
230
CLI Commands Used to Modify RADIUS Attributes
Juniper Networks
Command Keyword VSA Number
l2cd-min-data-rate-up [26-115]
l2cd-min-data-rate-dn [26-116]
l2cd-att-data-rate-up [26-117]
l2cd-att-data-rate-dn [26-118]
l2cd-max-data-rate-up [26-119]
l2cd-max-data-rate-dn [26-120]
l2cd-min-lp-data-rate-up [26-121]
l2cd-min-lp-data-rate-dn [26-122]
l2cd-max-interlv-delay-up [26-123]
l2cd-act-interlv-delay-up [26-124]
l2cd-max-interlv-delay-dn [26-125]
l2cd-act-interlv-delay-dn [26-126]
l2cd-dsl-line-state [26-127]
l2cd-dsl-type [26-128]
Example
host1(config)#radius include l2cd-acc-loop-cir-id acct-start enable
Use the no version to restore the default behavior, disable.
See radius include
Juniper Networks ANCP
VSA Name Type
Min-Data-Rate-Up 4
Min-Data-Rate-Dn 4
Att-Data-Rate-Up 4
Att-Data-Rate-Dn 4
Max-Data-Rate-Up 4
Max-Data-Rate-Dn 4
Min-LP-Data-Rate-Up 4
Min-LP-Data-Rate-Dn 4
Max-Interlv-Delay-Up 4
Act-Interlv-Delay-Up 4
Max-Interlv-Delay-Dn 4
Act-Interlv-Delay-Dn 4
DSL-Line-State 4
DSL-Type 4
ANCP
Subtype
131
132
133
134
135
136
137
138
139
140
141
142
143
144