Dhcp Local Server Configuration Tasks - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

For information about defining IP addresses, see the Configuring IP chapter in JUNOSe
IP, IPv6, and IGP Configuration Guide.

DHCP Local Server Configuration Tasks

This section covers the configuration tasks for equal-access and standalone modes.
Perform the appropriate procedure:
1.
2.
3.
For both equal-access and standalone modes, configure the DHCP local server.
See "Configuring AAA Authentication for DHCP Local Server Standalone Mode"
on page 481 for a sample configuration.
For standalone mode, optionally configure the router to use AAA authentication
for DHCP requests from subscribers.
See "Configuring AAA Authentication for DHCP Local Server Standalone Mode"
on page 481 for a sample configuration.
For non-PPP equal access, configure the router to work with the SRC software.
See "Configuring the Router to Work with the SRC Software" on page 486 for a
sample configuration.
Chapter 18: DHCP Local Server Overview
DHCP Local Server Configuration Tasks
469