Tunnel-Server-Auth-Id; Framed-Interface-Id - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide
radius include tunnel-client-auth-id

[91] Tunnel-Server-Auth-Id

Use the following command to manage the Tunnel-Server-Auth-Id RADIUS attribute.
radius include tunnel-server-auth-id

[96] Framed-Interface-Id

Use the following command to manage the Framed-Interface-Id RADIUS attribute.
radius include framed-interface-id
210
CLI Commands Used to Modify RADIUS Attributes
radius include tunnel-client-auth-id
Use to include the Tunnel-Client-Auth-Id attribute in Access-Request, Acct-Start,
or Acct-Stop messages.
You can control inclusion of the Tunnel-Client-Auth-Id attribute by enabling or
disabling this command.
See radius include
Example
host1(config)#radius include tunnel-client-auth-id access-request disable
Use the no version to restore the default, enable.
radius include tunnel-server-auth-id
Use to include the Tunnel-Server-Auth-Id attribute in Access-Request, Acct-Start,
or Acct-Stop messages.
You can control inclusion of the Tunnel-Server-Auth-Id attribute by enabling or
disabling this command.
See radius include
Example
host1(config)#radius include tunnel-server-auth-id acct-start enable
Use the no version to restore the default, enable.
radius include framed-interface-id
Use to include the Framed-Interface-Id attribute in Access-Request, Acct-Start,
or Acct-Stop messages.
You can control inclusion of the Framed-Interface-Id attribute by enabling or
disabling this command.