Ancp-Related Juniper Networks Vsas; Table 44: Ancp (L2C)-Related Keywords For Radius Include Command - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

ANCP-Related Juniper Networks VSAs

You use the radius include command to specify information about Access Node
Control Protocol (ANCP), also known as Layer 2 Control (L2C), that you want to
include in the RADIUS Access-Request, Acct-Start, and Acct-Stop messages. Also, if
you specify Acct-Stop messages, the router includes ANCP information in Interim-Acct
messages that the router sends to RADIUS. By default, the router does not include
the ANCP-related information provided by the Juniper Networks VSAs in RADIUS
messages.
These Juniper Networks ANCP-related VSAs are based on definitions in GSMP
extensions for layer2 control (L2C) Topology Discovery and Line
Configuration draft-wadhwa-gsmp-l2control-configuration-00.txt (July 2006
expiration).
radius include l2cd-keyword

Table 44: ANCP (L2C)-Related Keywords for radius include Command

See radius include
Example
host1(config)#radius include ipv6-accounting acct-stop enable
Use the no version to restore the default, disable.
Use to include ANCP-related Juniper Networks VSAs in Access-Request, Acct-Start,
and Acct-Stop messages that the router sends to RADIUS. If you enable inclusion
of the ANCP-related VSAs in Acct-Stop messages, the router also includes the
VSAs in Interim-Acct messages. Inclusion is disabled by default.
You must enable ANCP discovery with the discovery-mode command prior to
configuring the radius include command with the ANCP-related VSAs. Configuring
discovery mode enables the RADIUS authentication server to retrieve ANCP
information.
Table 44 on page 229 lists the ANCP (L2C)-related keywords that you can use in
the radius include command and the associated Juniper Networks VSAs. The
table also indicates the mappings between ANCP parameters and the VSAs.
Juniper Networks
Command Keyword VSA Number
l2cd-acc-loop-cir-id [26-110]
l2cd-acc-aggr-cir-id-bin [26-111]
l2cd-acc-aggr-cir-id-asc [26-112]
l2cd-act-data-rate-up [26-113]
l2cd-act-data-rate-dn [26-114]
Chapter 3: Configuring RADIUS Attributes
Juniper Networks
VSA Name
Acc-Loop-Cir-Id
Acc-Aggr-Cir-Id-Bin
Acc-Aggr-Cir-Id-Asc
Act-Data-Rate-Up
Act-Data-Rate-Dn
CLI Commands Used to Modify RADIUS Attributes
ANCP ANCP
Type Subtype
1 –
2 –
3 –
4 129
4 130
229