Chapter 8 Monitoring Radius; Monitoring Override Settings Of Radius Ietf Attributes - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Chapter 8
Monitoring RADIUS

Monitoring Override Settings of RADIUS IETF Attributes

Purpose
This chapter describes how to monitor the RADIUS attributes, RADIUS
dynamic-request server, and RADIUS relay.
RADIUS topics are described in the following sections:
Monitoring Override Settings of RADIUS IETF Attributes on page 297
Monitoring the NAS-Port-Format RADIUS Attribute on page 298
Monitoring the Calling-Station-Id RADIUS Attribute on page 299
Monitoring the NAS-Identifier RADIUS Attribute on page 299
Monitoring the Format of the Remote-Circuit-ID for RADIUS on page 300
Monitoring the Delimiter Character in the Remote-Circuit-ID for
RADIUS on page 300
Monitoring the Acct-Session-Id RADIUS Attribute on page 300
Monitoring the DSL-Port-Type RADIUS Attribute on page 301
Monitoring the Connect-Info RADIUS Attribute on page 301
Monitoring the NAS-Port-ID RADIUS Attribute on page 301
Monitoring Included RADIUS Attributes on page 302
Monitoring Ignored RADIUS Attributes on page 304
Setting the Baseline for RADIUS Dynamic-Request Server Statistics on page 304
Monitoring RADIUS Dynamic-Request Server Statistics on page 305
Monitoring the Configuration of the RADIUS Dynamic-Request Server on page 306
Setting a Baseline for RADIUS Relay Statistics on page 307
Monitoring RADIUS Relay Server Statistics on page 307
Monitoring the Configuration of the RADIUS Relay Server on page 309
Monitoring the Status of RADIUS Relay UDP Checksums on page 310
Monitoring the Status of ICR Partition Accounting on page 310
Display the current override setting for RADIUS IETF attributes. You can monitor the
NAS-IP-Address [4], NAS-Port-Id [87], Calling-Station-Id [31], and NAS-Identifier [32]
attributes.
Monitoring Override Settings of RADIUS IETF Attributes
297