Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 300

JUNOSe 11.0.x Broadband Access Configuration Guide
Table 50: Juniper Networks (Vendor ID 4874) VSA Formats (continued)
Attribute
Number Attribute Name
[26-2] Local-Address-Pool
[26-3] Local-Interface
[26-4] Primary-DNS
[26-5] Secondary-DNS
[26-6] Primary-WINS (NBNS)
[26-7] Secondary-WINS
(NBNS)
[26-8] Tunnel-Virtual-Router
[26-9] Tunnel-Password
[26-10] Ingress-Policy-Name
[26-11] Egress-Policy-Name
[26-12] Ingress-Statistics
[26-13] Egress-Statistics
260
Juniper Networks VSAs
Description
Name of an assigned address pool
that should be used to assign an
address for the user
Same as RADIUS attribute 88,
Framed-Pool
Interface to apply to the E Series side of
the connection
The interface value can be one of the
following:
The IP address (with subnet mask)
The loopback interface
B-RAS user's DNS address negotiated
during IPCP
4-octet IP address
B-RAS user's DNS address negotiated
during IPCP
4-octet IP address
B-RAS user's WINS (NBNS) address
negotiated during IPCP
4-octet IP address
B-RAS user's WINS (NBNS) address
negotiated during IPCP
4-octet IP address
Virtual router name for tunnel connection
Tunnel password in cleartext
Input policy name to apply to B-RAS user's
interface
Output policy name to apply to B-RAS
user's interface
Enable or disable input statistics on B-RAS
user's interface
Enable or disable output statistics on B-RAS
user's interface
Subtype
Length Length Value
len sublen string:
address-pool-name
len sublen string: local-interface
12 6 integer: 4-byte
primary-dns-address
12 6 integer: 4-byte
secondary-dns-address
12 6 integer: 4-byte
primary-wins-address
12 6 integer: 4-byte
secondary-wins-
address
len sublen string:
tunnel-virtual-router
len sublen string:
tunnel-password
len sublen string:
input-policy-name
len sublen string:
output-policy-name
12 6 integer: 0 = disable,
1 = enable
12 6 integer: 0 = disable,
1 = enable