Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 320

JUNOSe 11.0.x Broadband Access Configuration Guide
Table 54: Default L2TP Mappings (continued)
280
L2TP Terminate Reasons
L2TP Terminate Reason
session rx wen no resources
session timeout connection
session timeout inactivity
session timeout session
session timeout upper create
session transmit speed unavailable
session tunnel down
session tunnel failed
session tunnel switch profile deleted
session tunneled interface down
session unknown cause
session upper create failed
session upper removed
session warmstart not operational
session warmstart recovery error
session warmstart upper not restacked
tunnel admin close
tunnel admin drain
tunnel control channel failed
tunnel created no sessions
tunnel destination address changed
tunnel destination down
tunnel failover protocol no resources for recovery tunnel
tunnel failover protocol no resources for session resync
tunnel failover protocol not supported
tunnel failover protocol not supported by peer
RADIUS Acct-Terminate-Cause
Code Description
10 nas request
10 nas request
4 idle timeout
5 session timeout
9 nas error
9 nas error
15 service unavailable
15 service unavailable
6 admin reset
8 port error
9 nas error
9 nas error
15 service unavailable
15 service unavailable
15 service unavailable
10 nas request
6 admin reset
6 admin reset
15 service unavailable
1 user request
6 admin reset
10 nas request
15 service unavailable
15 service unavailable
15 service unavailable
15 service unavailable