Table 144: Service Manager Radius Attributes - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Table 144: Service Manager RADIUS Attributes

Attribute
Number Attribute Name
[1] User-Name (used with
Virtual-Router, Juniper
Networks VSA 26-1)
[8] Framed-IP-Address
(used with
Virtual-Router, Juniper
Networks VSA 26-1)
[26-65] Activate-Service
[26-66] Deactivate-Service
[26-67] Service-Volume
[26-68] Service-Timeout
[26-69] Service-Statistics
[26-83] Service-Session
[26-140] Service-Interim-Acct-
Interval
[31] Calling-Station-ID
[44] Acct-Session-ID
Chapter 27: Configuring Service Manager
RADIUS Message
Type VSA Description
Access-Accept Uniquely identifies the subscriber
session
Access-Accept Uniquely identifies the subscriber
session
Access-Accept and Name of the service to be activated;
CoA-Request includes parameter values; a tagged
VSA
Access-Accept and Name of the service to be
CoA-Request deactivated
Note: This VSA is only used by CoA.
Access-Accept and Number of MB of traffic that the
CoA-Request service can consume; the service is
terminated when output byte count
exceeds this value; a tagged VSA
Access-Accept and Number of seconds that the service
CoA-Request is to remain active; the service is
terminated when the time expires;
a tagged VSA
Access-Accept and Statistics configuration; a tagged VSA:
CoA-Request 0 = disable
1 = timestamp only
2 = timestamp and volume
For service Name of the service (including
sessions only: parameter values) with which the
Acct-Start statistics are associated
Acct-Stop
Interim-Acct
Access-Accept and Number of seconds between
CoA-Request accounting updates for a service; a
tagged VSA
Access-Accept Uniquely identifies the subscriber
session
Acct-Start Accounting identifier that makes it
Acct-Stop easy to match start and stop records
Interim-Acct in a log file; the format is extended
to include a colon-separated value
that uniquely identifies the subscriber
session
Using RADIUS to Manage Subscriber Service Sessions
657