Table 30: Show Sscc Info Output Fields - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Local Source: FastEthernet 0/0, Local Source Address: 10.13.5.61
The configured transport router is: default
The configured retry timer is (seconds): 90
The connection state is: NoConnection
SSC Client Statistics:
Policy Commands received
Policy Commands(List)
Policy Commands(Acct)
Bad Policy Cmds received
Error Policy Cmds received 0
Policy Reports sent
Connection Open requests
Connection Open completed
Connection Closed sent
Connection Closed remotely 0
Create Interfaces sent
Delete Interfaces sent
Active IP Interfaces
IP Interface Transitions
Synchronizes received
Synchronize Complete sent
Internal Errors
Communication Errors
Tokens Seen
Active Tokens
Token Transitions
Token Creates Sent
Token Deletes Sent
Active Addresses
Address Transitions
Create Addresses Sent
Delete Addresses Sent
Authentication Successes
Authentication Failures
Table 30 on page 149 lists the show sscc info command output fields.
Meaning

Table 30: show sscc info Output Fields

Field Name
The SSC client configured
protocols
The SSC client configured
servers
Local Source
Local Source Address
The configured transport
router is
The configured retry timer
is (seconds)
The connection state is
Chapter 2: Monitoring and Troubleshooting Remote Access
0
0
0
0
0
0
0
0
0
0
2
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Field Description
Protocols that are enabled on the virtual router for policy and QoS
management by the SRC software
IP addresses of the primary, secondary, and tertiary SAEs
Fixed source interface for the TCP/COPS connection
Fixed source address for the TCP/COPS connection
Router on which is TCP/COPS connection is established
Delay period the client waits for a response from the SAE before
submitting request again
Current state of the TCP/COPS connection
Monitoring SRC Client Connection Status
149