Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 622

JUNOSe 11.0.x Broadband Access Configuration Guide
domain
include circuit-identifier
include dhcp-option 82
582
Subscriber Management Commands
deny Drop addresses that appear in the source address range
primary Associate the source prefix with the primary IP interface
Example
host1(config-if)#clear ip demux
There is no no version.
See clear ip demux
Use to specify a domain for an IP service profile.
The domain is included in a username that is dynamically created by JUNOSe
subscriber management.
Specify a domain name with up to 32 ASCII characters.
Example
host1(config-service-profile)#domain eastcoast
Use the no version to remove the domain from the IP service profile.
See domain
Use to include the circuit identifier in the username that is dynamically created
by JUNOSe subscriber management.
Specify one of the following circuit types: atm or vlan.
Use the optional prepend-circuit-type keyword to specify that the circuit type
is prepended to the circuit identifier in the username.
Example
host1(config-service-profile)#include circuit-identifier atm prepend-circuit-type
Use the no version to disable inclusion of the circuit identifier in the username.
See include circuit-identifier
Use to include a suboption of the DHCP relay agent information option (option
82) in the username that is dynamically created by JUNOSe subscriber
management.
Specify one of the following suboptions: agent-circuit-id or agent-remote-id.
Example
host1(config-service-profile)#include dhcp-option 82 agent-circuit-id