Tacacs+ Platform Considerations; Tacacs+ References - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Table 65: TACACS+ Accounting Information (continued)

TACACS+ Platform Considerations

TACACS+ is supported on all E Series routers. For information about the modules
supported on E Series routers:

TACACS+ References

For additional information about the TACACS+ protocol, see the following resources:
NOTE: IETF drafts are valid for only 6 months from the date of issuance. They must
be considered as works in progress. Please refer to the IETF Web site at
http://www.ietf.org for the latest drafts.
Field/Attribute Location
user Packet body
port Packet body
rem-addr Packet body
service AVP
cmd AVP
task_id AVP
elapsed_time AVP
timezone AVP
See the ERX Module Guide for modules supported on ERX7xx models, ERX14xx
models, and the ERX310 Broadband Services Router.
See the E120 and E320 Module Guide for modules supported on the E120 and
E320 Broadband Services Routers.
The TACACS+ Protocol, Version 1.78 draft-grant-tacacs-02.txt (January 1997
expiration)
RFC 2865 Remote Authentication Dial In User Service (RADIUS) (June 2000)
Chapter 9: Configuring TACACS+
Description
Name of user running the Exec session or CLI command
NAS port used by the Exec session or CLI command
User's remote location; either an IP address or the caller
ID
User's primary service: Shell
CLI command that is to be executed: specified for
Command-level accounting only
Unique sequential identifier used to match start and stop
records for a task
Elapsed time in seconds for the task execution: specified
for Exec-level accounting stop records only
Time zone abbreviation used for all timestamps
TACACS+ Platform Considerations
315