JUNOSe 11.0.x Broadband Access Configuration Guide
radius icr-partition-accounting
All IPv6 Accounting Attributes
Use the following command to manage all IPv6 accounting attributes:
radius include ipv6-accounting
228
CLI Commands Used to Modify RADIUS Attributes
Use to include the ICR-Partition-Id attribute in Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
Example
host1(config)#radius include icr-partition-id acct-start enable
Use the no version to restore the default, disable.
Use to enable or disable sending of the ICR Partition-Accounting-On or
Partition-Accounting-Off messages to the RADIUS servers
Both Partition-Accounting messages include the ICR-Partition-Id VSA. Also, both
these messages are sent to the RADIUS accounting server configured on the
virtual router where the ICR partition is configured or the virtual router on which
the ICR control interface is set up.
You can configure ICR partition accounting per virtual router.
Example
host1(config)#radius icr-partition-accounting enable
Use the no version to restore the default, disable.
radius include ipv6-accounting
Use to include the following supported IPv6 accounting attributes in Acct-Stop
messages:
IPv6-Acct-Input-Octets [26-151]
IPv6-Acct-Output-Octets [26-152]
IPv6-Acct-Input-Packets [26-153]
IPv6-Acct-Output-Packets [26-154]
IPv6-Acct-Input-Gigawords [26-155]
IPv6-Acct-Output-Gigawords [26-156]
If you enable inclusion of the IPv6 accounting-related VSAs in Acct-Stop messages,
the router also includes the VSAs in Interim-Acct messages.
You can control inclusion of the IPv6 accounting attributes by enabling or
disabling this command.