Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 99

ip local pool
ip local pool snmpTrap
ip local pool warning
ip local shared-pool
You can modify an existing alias with a different local address pool name.
When a local address pool is deleted, all aliases with the matching pool name
are also deleted.
Example
host1(config)#ip local alias groupB pool-name addrpool_10
Use the no version to remove the alias name.
See ip local alias
Use to map an address pool name to a range of local addresses.
You can create a pool with no address ranges configured for it.
A name may contain up to 16 characters.
Example
host1(config)#ip local pool addrpool_10 192.168.56.10 192.168.56.15
Use the no version to remove the local pool (all ranges), or the specified range.
See ip local pool
Use to enable SNMP pool utilization traps.
Example
host 1(config)#ip local pool addr_test snmpTrap
Use the no version to disable SNMP pool utilization traps.
See ip local pool snmpTrap
Use to set SNMP utilization warning threshold values.
Example
host1(config)#ip local pool addr_test warning 90 80
Use the no version to reset the attributes to their default values; high threshold
85, abated threshold 75.
See ip local pool warning
Use to create a local shared address pool and to specify the DHCP address pool
that provides the addresses.
You can reference a DHCP address pool that has not yet been configured.
Chapter 1: Configuring Remote Access
Configuring Local Address Servers
59