Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 136

JUNOSe 11.0.x Broadband Access Configuration Guide
Proprietary PIB
Non-proprietary PIBs
The COPS-PR support in JUNOSe Software uses the proprietary PIB. This PIB consists
of a series of tables that is supported in previous JUNOSe software releases, including
the proprietary accounting and address assignment mechanisms.
You can force the router to restart a COPS connection to, and resynchronize with, a
PDP, without disabling the SRC client's COPS support. The SRC software and the
SRC client maintain common state information in PIBs that both the SRC software
and the SRC client use. Previously, you disabled the SRC client and reenabled it to
start synchronization. The disabling of the SRC client's COPS support was undesirable
for the applications that required resynchronization in addition to maintaining the
COPS support. If the state of the SRC software is not synchronized with the router,
the SRC software may be required to initiate resynchronization from the router.
The proprietary PIB provides the Policy Manager and QoS Manager functionality
shown in the following lists.
The JUNOSE-IP-PIB file is updated with each JUNOSe release. Since the PIB is
implemented by both Juniper Networks SRC and JUNOSe devices, distribution of the
96
Configuring the SRC Client
JUNOSe-IP-PIB This PIB defines the data model for manipulating IP service
policies and addresses offered through DHCP in JUNOSe software.
COPS-PR-SPPI
COPS-PR-SPPI-TC
DIFFSERV-PIB
FRAMEWORK-FEEDBACK-PIB
FRAMEWORK-PIB
FRAMEWORK-TC-PIB
Policy Manager
Committed access rate
Packet filtering
Policy routing
QoS classification and marking
Rate limiting
Traffic class
QoS Manager
Queues
Schedulers
Traffic classes