Framed-Compression; Class - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide
radius ignore framed-ip-netmask

[13] Framed-Compression

Use the following command to manage the Framed-Compression RADIUS attribute.
radius include framed-compression

[25] Class

Use the following command to manage the Class RADIUS attribute.
radius include class
190
CLI Commands Used to Modify RADIUS Attributes
Use to cause the Framed-Ip-Netmask attribute to be ignored in Access-Accept
messages.
You can control this behavior by enabling or disabling this command.
If the subnet mask is specified by the Frame-Ip-Netmask attribute in the RADIUS
user profile, the router passes the mask and IP address to the CPE during IPCP
negotiations. When this command is enabled, the default subnet mask
255.255.255.255 is provided by AAA and used for IPCP negotiations.
Enabling the command guards against any breaks in the negotiation.
See radius ignore
Example
host1(config)#radius ignore framed-ip-netmask disable
Use the no version to restore the default, enable.
radius include framed-compression
Use to include the Framed-Compression attribute in Acct-Start or Acct-Stop
messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include framed-compression acct-start disable
Use the no version to restore the default, enable.
radius include class
Use to include the Class attribute in Acct-Start or Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include