Configuring Logs In An Infranet Controller; Configuring Radius Attribute Logs (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

CHAPTER 21

Configuring Logs in an Infranet Controller

Configuring RADIUS Attribute Logs (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Configuring RADIUS Attribute Logs (NSM Procedure) on page 211
Configuring Event Logs (NSM Procedure) on page 212
Configuring User Access Logs (NSM Procedure) on page 213
Configuring Administrator Access Logs (NSM Procedure) on page 214
Configuring Client-Side Logs (NSM Procedure) on page 216
Configuring the Infranet Controller as an SNMP Agent (NSM Procedure) on page 216
Configuring Custom Log Filters (NSM Procedure) on page 218
You can configure the Infranet Controller to enable or disable RADIUS attribute logging
and obtain a granular record of RADIUS authentication attempts using configurable,
detailed authentication logs.
To configure RADIUS attribute logging:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the Infranet Controller device for
2.
which you want to configure RADIUS attribute logging.
Click the Configuration tab. In the configuration tree, select UAC > Network Access
3.
> RADIUS Attributes > RADIUS Attribute Logging.
Select Authentication Success Log Message to record events with successful
4.
authentication attempts.
From the Non-members area, select the attribute for which successful authentication
5.
attempts should be recorded and then move it to the Members area.
Select Authentication Reject Log Message to record events with unsuccessful
6.
authentication attempts.
From the Non-members area, select the attribute for which unsuccessful
7.
authentication attempts should be recorded and then move it to the Members area.
Click one:
8.
OK-Saves the changes.
211