Ipv6-Primary-Dns; Ipv6-Secondary-Dns - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide

[26-47] Ipv6-Primary-DNS

Use the following command to manage the IPv6-Primary-DNS RADIUS attribute.
radius include ipv6-primary-dns

[26-48] Ipv6-Secondary-DNS

Use the following command to manage the Ipv6-Secondary-DNS RADIUS attribute.
radius include ipv6-secondary-dns
220
CLI Commands Used to Modify RADIUS Attributes
Use to include the Ipv6-Local-Interface attribute in Acct-Start, or Acct-Stop
messages.
You can control inclusion of the attribute by enabling or disabling this command.
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.
If IPv6 local interface is configured in the AAA domain map and is not returned
from the RADIUS server, the Acct-Start, Acct-Stop, or Interim-Acct messages
report the value configured in the domain map.
See radius include
Example
host1(config)#radius include ipv6-local-interface acct-start enable
Use the no version to restore the default, disable.
radius include ipv6-primary-dns
Use to include the IPv6-Primary-DNS attribute in Acct-Start, or Acct-Stop
messages.
You can control inclusion of the attribute by enabling or disabling this command.
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.
If the IPv6 primary DNS server is configured in the AAA domain map and is not
returned from the RADIUS server, the Acct-Start, Acct-Stop, or Interim-Acct
messages report the value configured in the AAA domain map.
See radius include
Example
host1(config)#radius include ipv6-primary-dns acct-start enable
Use the no version to restore the default, disable.
radius include ipv6-secondary-dns