Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 237

radius include nas-identifier
radius override nas-info
radius remote-circuit-id-format
Use to set a value for the NAS-Identifier attribute. This value is used in the
NAS-Identifier attribute for authentication and accounting requests.
Example
host1(config)#radius nas-identifier fox
Use the no version to delete the NAS-Identifier.
See radius nas-identifier
Use to include the NAS-Identifier attribute in Access-Request, Acct-Start, Acct-Stop,
Acct-On, and Acct-Off messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include nas-identifier acct-start disable
Use the no version to restore the default, enable.
Use in the correct virtual router context to override the standard use of
NAS-IP-Address and NAS-Identifier attributes for AAA broadcast accounting;
specifies that the attributes for the authentication virtual router be included in
accounting packets instead of the attributes for the virtual router that generates
the accounting information.
See radius override nas-info
Example
host1(config)#virtual-router vrXyz1
host1:vrXyz1(config)#radius override nas-info
Use the no version to restore the standard use of the NAS-IP-Address and
NAS-Identification attributes.
Use to configure the format of the PPPoE remote circuit ID value captured from
a DSLAM.
You can format the PPPoE remote circuit ID value to include either or both of
the agent-circuit-ID (suboption 1) and agent-remote-id (suboption 2) suboptions
of the DHCP relay agent information option (option 82) or the PPPoE intermediate
agent tags.
By default, the router formats the PPPoE remote circuit ID to include only the
agent-circuit-id suboption.
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
197