Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 733

ip http max-connection-time
ip http port
ip http redirectUrl
Use to allow only subscribers on the specified standard IP access list to connect
to the HTTP local server.
Example
host1(config)#ip http access-class chicagoList
Use the no version to remove the association between the access list and the
HTTP local server.
See ip http access-class
Use to specify the maximum time that the HTTP local server maintains an inactive
connection.
Specify a time in the range 3–7200 seconds, or 0. A value of 0 causes the server
to maintain an inactive connection indefinitely.
Example
host1(config)#ip http max-connection-time 1000
Use the no version to restore the default time, 30 seconds.
See ip http max-connection-time
Use to specify the port on which the HTTP local server receives connection
attempts for IPv4 exception packets.
Specify a port number in the range 1–65535.
Example
host1(config)#ip http port 8080
Use the no version to restore the default port number, 80.
See ip http port
Use to specify the URL to which a subscriber's HTTP access session is redirected.
The first access session is typically used by the Service Manager application to
provide initial provisioning and service selection for the subscriber.
HTTP redirect is per-interface; use the command in Profile Configuration mode
for dynamic interfaces; use the command in Interface Configuration mode or
Subinterface Configuration mode for static interfaces.
The redirect URL can be a maximum of 64 characters.
Chapter 27: Configuring Service Manager
Service Definition Examples
693