Configuring Dhcp Relay Proxy - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide
The remote-id-only keyword specifies the Agent Remote ID suboption, which contains
a value only when (1) the interface is a dynamic ATM interface and (2) the subscriber
command is used to configure a username and domain name for the interface. If
both conditions are met, the suboption contains a string with the username and
domain name in the format: username@domainname. The remote-id-only keyword
disables support for the Agent Circuit ID suboption.
If you do not explicitly specify the circuit-id-only or remote-id-only keyword, both
suboptions are used.
Related Topics

Configuring DHCP Relay Proxy

The DHCP relay proxy is an enhancement to the E Series router's DHCP relay
component. The DHCP relay proxy manages host routes for DHCP clients, and
determines which offer to use when there are multiple DHCP servers configured.
512
Configuring DHCP Relay Proxy
lag bundleA.1:2
relayVr:lag bundleA:2
bostonHost:lag bundleA.1:2
LAG interface with Stacked VLAN
[<hostname>|<vrname>:]<interface type> <bundle name>[.<sub-if>]:
<svlan id>-<vlan id>
Examples:
lag bundleA.1:2-3
relayVr:lag bundleA:2-3
bostonHost:lag bundleA.1:2-3
radius remote-circuit-id-format
set dhcp relay
set dhcp relay agent
set dhcp relay agent sub-option
set dhcp relay assign-giaddr-source-ip
set dhcp relay broadcast-flag-replies
set dhcp relay giaddr-selects-interface
set dhcp relay layer2-unicast-replies
set dhcp relay options
set dhcp relay override
set dhcp relay preserve-trusted-client-option
set dhcp relay trust-all
set dhcp vendor-option