Ipv6-Virtual-Router; Ipv6-Local-Interface - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

[26-45] Ipv6-Virtual-Router

Use the following command to manage the IPv6-Virtual-Router RADIUS attribute.
radius include ipv6-virtual-router

[26-46] Ipv6-Local-Interface

Use the following command to manage the Ipv6-Local-Interface RADIUS attribute.
radius include ipv6-local-interface
Use to include the Tunnel-Interface-Id attribute in Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include tunnel-interface-id enable
Use the no version to restore the default, disable.
radius include ipv6-virtual-router
Use to include the Ipv6-Virtual-Router attribute in Acct-Start, or Acct-Stop
messages.
You can control inclusion of the attribute by enabling or disabling this command.
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.
If the IPv6 virtual router is configured in the AAA domain map and is not returned
from the RADIUS server, the Acct-Start, Acct-Stop, or Interim-Acct messages
report the value configured in the domain map.
If IPv6 virtual router is not configured in the AAA domain map and is not returned
from the RADIUS server, it is not included in the Acct-Start message because the
value is not yet known. If the IPv6 virtual router context is configured from the
profile, it is reported in the immediate-update message for DHCPv6 prefix
delegation.
See radius include
Example
host1(config)#radius include ipv6-virtual-router acct-start enable
Use the no version to restore the default, disable.
radius include ipv6-local-interface
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
219