Quick Setup Submenus - Printronix SLPA7000 User Manual

Chapter 3
QUICK SETUP Menu
QUICK SETUP
(cont. from previous page)
SMT: Status
Disabled*
SMT: Sel Toolset
Toolset [1]*
EPC
SMT: Select Tool
zEPC
NOTE: Many QUICK SETUP submenus are available in other main menus.

QUICK SETUP Submenus

Print Intensity
This menu item specifies the level of thermal energy from the printhead to be
used for the type of media and ribbon installed.
Large numbers imply more heat (thermal energy) to be applied for each dot.
This has a significant effect on print quality. The print intensity and speed
must match the media and ribbon type to obtain the best possible print quality
and barcode grades.
The range is –15 through +15:
•
In Transfer mode, the default is –3.
•
In Direct Thermal mode, the default is 0.
88
Enabled
Toolset [1] to Toolset [4]
1 1 1
GTIN UPCA
2, 3 2, 3 2, 3
zGTIN zUPCA zEAN8
(Refer to the T5000e User's Manual .)
Changes made in the QUICK SETUP menu are updated in the other
main menus, and vice versa.
1 1
EAN8 EAN13 UCC128
2, 3 2, 3
zEAN13 zUCC128
Notes:
* = Default.
1
Appears only if Toolset [1] is selected under
SMT: Sel Toolset.
2
Appears only if Toolset [2] is selected under
SMT: Sel Toolset.
3
Undocumented options are reserved for internal
use and future design.
1
2, 3