List Of Messages - Printronix SLPA7000 User Manual

List Of Messages

Find the message in the Message List below and follow the suggested
procedure.
After correcting an error, press the PAUSE key to erase the message and put
the printer in the offline mode. If an error is not cleared, the printer will try to
print again but will display the error message until the error is cleared.
Message
I I I I I I I I I I I I I I I I
— OR —
I
I
06 HOST REQUEST
08 HOLD PRINT
TIMEOUT
Table 8. Message List
Explanation
1. The Flash SIMM (Single
In-line Memory Module) is
not installed.
2. The Flash SIMM has
corrupt boot code.
Status message in the CT
emulation: the host computer or
print controller requires
attention.
Status message in the CT
emulation: the printer was
offline more than 10 minutes
and the "Intervention Required"
parameter is set to "Send to
Host."
List Of Messages
Solution
1. Install the Flash SIMM.
2. If the message reappears,
replace the Flash SIMM
with a new Flash SIMM.
3. Download the latest level of
software.
4. If the message reappears,
replace the control panel
and cable.
5. If the message reappears,
replace the controller
PCBA. Write down the
message and return it with
the defective board.
Proceed to the next step.
6. Download the latest level of
software.
Not a printer problem.
Press PAUSE to put the printer
online.
165