Printronix SLPA7000 User Manual page 135

Set Sharing
This option allows character sets to be shared between the active LP+
protocol and the active emulation. If CT is installed and active, choosing a
character set in the CT activates that character set in the active emulation and
LP+ protocols. (These changes are not visible on the front panel.) If Set
Sharing is not selected, only the LP+ protocol will share the CT's character
set.
Switching host interfaces from CT to Centronics when Set Sharing is enabled
causes the LP+ protocol character set to change to the same character set as
the active emulation, if possible.
In a non-CT system, changing character sets in the LP+ protocol causes the
active emulation to change to the same character set if the selected set exists
in the active emulation. If the active emulation has no access to the selected
set, no changes are made. Selecting a new character set in the active
emulation causes the LP+ protocol to change to the same character set if the
selected character set exists in the active LP+ protocol. Not all sets are
shared between emulations in the Standard group of character sets. As a
result, selecting a set in the Standard group of the LP+ protocol or active
emulation may or may not cause the other emulation to have the same set.
NOTE: The front panel option, Set Sharing, has no effect on the LP+ and
CT/LP+ builds. The option only applies to the builds with PPI1.
The options are Disable (the factory default) and Enable.
Admin User
•
Disable.
•
Enable. When enabled, this function permits access to submenus which
would not normally be changed by a typical user.
The factory default is Disable.
Auto Locking
↵
•
Disable. The (ENTER) key must be locked manually.
•
Enable. The printer automatically locks the
last control panel key press.
The factory default is Disable.
Set Lock Key
Normally, to lock or unlock the printer menu, the ↓ and
the same time. The Set Lock Key parameter lets you choose different keys to
lock or unlock the printer menu. You may choose almost any group of keys as
the new lock and unlock keys. You cannot use the
combinations which are already used for another function. There is no limit to
how many keys can be selected.
To set the new lock key:
1. Go to the PRINTER CONTROL main menu and select "Set Lock Key."
PRINTER CONTROL Submenus
↵
key five minutes after the
↵
keys are pressed at
↵
key or any key
135