Table of Contents
Advertisement
Appendix E
Installation and Removal
5. Rotate the antenna upright.
6. Remove the top two M3x8mm screws securing the rear panel.
7. Slide the antenna plate over the antenna.
8. Align the plate over the two holes in the frame, then secure the plate
using the two M3x8mm screws.
9. Restore the printer to operation (page 224).
10. Refer to your printer's User's Manual or the Network Interface Card
User's Manual to configure the printer for the dual NIC wireless interface.
366
M3x8mm
Screw (2)
Upright Antenna
Figure 80. Installing the Antenna Plate
Antenna
Plate
Advertisement
Table of Contents
Troubleshooting
