Safety; Warnings And Cautions - Printronix SLPA7000 User Manual

Safety

Warnings And Cautions

WARNING
Printronix has provided the necessary guards and warnings within the
confines of the SLPA, but cannot anticipate each customer's individual
installation and operational environments. It is the customer's
responsibility to provide in-house safety guards to provide adequate
worker safety for their respective production settings.
WARNING
An input signal from the product sensor activates the SLPA when it is
powered on. Make certain that protective guards are properly secured
and that materials are clear of the applicator pad/printhead assembly
before powering on the SLPA.
WARNING
This manual includes instructions on basic operation and preventative
maintenance only. Only qualified technicians should perform service
procedures, i.e, procedures requiring access to the rear compartment or
power entry module of the SLPA.
WARNING
Both surge protection for the electrical supply and pressure relief for
the pneumatic supply are strongly recommended. Failure to properly
protect against extreme fluctuations in the supply sources could result
in operator injury or damage to equipment.
CAUTION
Power off the SLPA and disconnect both the power source and the air
supply prior to doing any maintenance, adjustments, and/or parts
replacement which do not require these systems to be powered on.
CAUTION
Read and become familiar with all of the instructions in this manual
before proceeding to operate the SLPA.
CAUTION
Any external communications cables to be used with the SLPA must be
properly shielded and grounded. Failure to provide proper shielding or
grounding for these cables could result in malfunctioning or damage to
the SLPA.
CAUTION
When handling the SLPA, do not rest or pivot it such that pressure may
be applied to the printhead assembly.
Warnings And Cautions
21