Printronix SLPA7000 User Manual page 97

RFID CONTROL Submenus
Label Retry
NOTE: Label Retry only applies when the Error Handling mode is set to
Overstrike.
This menu item selects the number of label retries that the RFID encoder will
attempt before declaring a fault. This may indicate a problem with the RFID
encoder, the antenna assembly, the printer setup, or the label stock. The
default is 10.
Max Retry Error
This menu item enables or disables the Max Retry Error menu item. If it is set
to Disable, errors are not declared and the print content for the current label is
discarded. The default is Enable.
Tag Write Cnt
This menu item displays on the control panel's LCD the number of tags
written since the last Clear Tag Stat operation has been initiated. (See "Clear
Tag Stat" below.)
Failed Tag Cnt
This menu item displays on the control panel's LCD the number of failed tag
write attempts since the last Clear Tag Stat operation has been initiated. (See
"Clear Tag Stat" below.)
Tag Void Cnt
This menu item always displays 0 unless the RFID encoder is used with an
attached online data validator. When used with a validator, Tag Void Cnt
represents how many valid RFID tags were overstruck due to bad bar code
scanning. Refer to the Online Data Validator User's Manual .
Tag Read Cnt
This menu item displays the number of tags read since the last Clear Tag Stat
(below).
Clear Tag Stat
This menu item clears the Tag Write Cnt, Failed Tag Cnt, Tag Void Cnt, and
Tag Read Cnt submenus.
F/W-Version
This menu item displays on the control panel's LCD the reader firmware
version.
97