Adjusting The Voltage - Printronix SLPA7000 User Manual

Smart label printer applicator

Hide thumbs Also See for SLPA7000:

Table of Contents

Adjusting The Voltage

The facing arrows indicate the selected voltage setting. (Figure 7.). If the

setting is incorrect, adjust the voltage as follows:

1. Set the power switch to O (Off).

2. Insert the tip of a flat tip screwdriver into the slot above the fuse holder

assembly, and twist to remove the assembly.

3. Flip over the fuse holder assembly and make sure the fuse is in the active

fuse location.

NOTE: Refer to "Electrical" on page 322 for fuse electrical specifications.

4. Reinsert the fuse holder assembly. Make sure the facing arrows are

aligned properly.

Figure 7. Adjusting the Voltage

Adjusting The Voltage