Table of Contents
Advertisement
DIP Switches
Two DIP switches, labeled 1 and 2, are mounted on the 10/100Base-T
interface inside the printer. The functions of these switches are explained
below.
Table 14. 10/100Base-T DIP Switch Settings
DIP Switch
1
2
OFF
OFF
Normal operation. The interface boots up using the
(up)
(up)
settings in flash memory rather than the default
settings.
ON
OFF
Factory default settings. The interface boots up and
(down)
(up)
all settings stored in flash memory are erased except
the Ethernet address and key value.
OFF
ON
Default IP. The interface boots up with factory default
(up)
(down)
settings, but the stored settings in flash memory
remain intact. Setting switch 2 to "ON" does not clear
any settings stored in flash memory; it boots the unit in
a different state with the settings in flash memory
temporarily ignored.
ON
ON
If the interface is connected to a network with link
(down)
(down)
integrity and is then reset, the interface will boot up in
download mode. If the unit is not connected to a
network, it will print a test page.
NIC Assembly
Description
247
Advertisement
Table of Contents
Troubleshooting
