Install The Dual Nic Wireless Interface - Printronix SLPA7000 User Manual

Appendix E
Installation and Removal

Install The Dual NIC Wireless Interface

1. Prepare the printer for maintenance (page 223).
CAUTION
To prevent electrostatic damage to electronic components, always wear
a properly grounded static wrist strap when you handle circuit boards.
2. Put on a static wrist strap and ground it to an unpainted part of the printer
frame. Touch the frame with the hand wearing the wrist strap.
3. Loosen one screw and remove the other screw that secures the blank I/O
plate to the rear of the printer frame, and set the plate aside. (Figure 52,
page 286, item 7.)
4. Loosen one screw and remove the other screw that secures the
Centronics parallel connector or current NIC to the rear of the printer
frame. (Figure 76.)
5. Unplug the Centronics parallel cable from the J112 receptacle on the
controller board.
6. Remove the Centronics parallel cable and current NIC (if installed) from
the printer.
J112
Screw (2)
Figure 76. Removing the Centronics Parallel Cable
7. Route the radio card connector end of the RF cable through the BNC
connector hole in the wireless interface.
362
Centronics
Parallel Cable
Centronics
Parallel Connector
NIC